21-04-2021, 08:24 AM
(This post was last modified: 21-04-2021, 08:31 AM by josemendez.)
(20-04-2021, 11:32 AM)josemendez Wrote: This can have a lot of different causes, but I don't have enough info to tell for sure:
- Simulation happening before input each frame, resulting in a 1-frame delay.
- Different interpolation settings for the rigidbody and the rope, resulting in several frames delay.
- Not enough pin constraint iterations.
If you could give more details regarding your setup I could help.
Hey jose, did you check you my configuration? If you say not enough pin constrait iterations? What do you mean? How I can adjust the constraint iterations? You mean from the obi solver? I tried 10 and 100 still no improvements.
