19-04-2021, 04:41 AM
I'm having the similar issue with emitter bouncing off the sphere when using the Sticky Blueprint. Obi Fluid purchased, Imported, then using sample scene "Fluid Viscosity" to create honey seeping off the sphere. I tried every solution I could find and nada. My installation: 2019.4.15f1, URP, Obi Fluid 4
I have attached 5 image consists of scene and the parameters in hoping that this provide an insight on this mess.
as a last resort, is it possible for me to get the patch as well? this might be the cure I need for my insanity...
I have attached 5 image consists of scene and the parameters in hoping that this provide an insight on this mess.
as a last resort, is it possible for me to get the patch as well? this might be the cure I need for my insanity...