01-02-2021, 05:11 PM
(This post was last modified: 01-02-2021, 08:04 PM by relevantname.)
Hi,
I have a rope and attached rigidbodies to this rope's both ends.
I wanted to draw on the object on the left with pulling the object attached to the end of the rope(object on the right) very fast.
When I pull it slowly, the behaviour is as expected. But when I increase the pull speed it does not behave very well because of the stretching(I guess). I'm setting the mass of the object on the left very low(like 0.01) when pulling, but it couldn't solve the problem.
P.s: I pull the object with using it's rigidbody, not with it's transform.
I attached two screenshots to describe my problem.
What settings should I apply to pull it correctly and very fast.
Thanks.
I have a rope and attached rigidbodies to this rope's both ends.
I wanted to draw on the object on the left with pulling the object attached to the end of the rope(object on the right) very fast.
When I pull it slowly, the behaviour is as expected. But when I increase the pull speed it does not behave very well because of the stretching(I guess). I'm setting the mass of the object on the left very low(like 0.01) when pulling, but it couldn't solve the problem.
P.s: I pull the object with using it's rigidbody, not with it's transform.
I attached two screenshots to describe my problem.
What settings should I apply to pull it correctly and very fast.
Thanks.