22-04-2020, 05:26 PM
I need to customise the behaviour of a softbody to make it more rigid and increase the damping, to make it behave less like a jelly and more like a balloon.
However the Deformation Resistance slider under Shape Matching Constraints only goes up to 1, which is not stiff enough, and I can't find anything related to damping.
Lowering the mass of the particles in the blueprint helps a little, but this seems like a bit of a hack, and setting the mass too low causes strange behaviour.
Does anyone have any suggestions? Thanks in advance.
However the Deformation Resistance slider under Shape Matching Constraints only goes up to 1, which is not stiff enough, and I can't find anything related to damping.
Lowering the mass of the particles in the blueprint helps a little, but this seems like a bit of a hack, and setting the mass too low causes strange behaviour.
Does anyone have any suggestions? Thanks in advance.