16-04-2020, 08:35 AM
(This post was last modified: 16-04-2020, 08:37 AM by josemendez.)
(15-04-2020, 11:53 PM)julianocortes Wrote: My question: is it possible I pass the coordinates (path) and OBI construct a cable like in picture I showed?
Hi,
Yes, you can define the initial path of a cable using control points.
However keep in mind that Obi is a physics simulator, and cables are dynamic. In an electrical circuit like the one shown in the image most cables are static, using a physics simulation for them seems like overkill, and will affect your performance negatively. Imho, a simple spline editor would be a simpler, cheaper choice if all you need is to define static cable paths.