[attachment=549]
I have object that need a rope to hook a load to move. I have to have the red circle in different position too.
In A,
If I change the position of the red circle, sometimes the rope stays there hanging the load. Is there anyway to update/reset, so it definitely follow the red circle? There are other time where it does follow, but the rope is swinging a lot. Is there any function to call that stop the swinging? It is just for a reset only.
In B,
If I have both of the them being fixed, the load just drops immediately, I don't know which way is the right way to set the joints up. Any suggestion?
Thanks.
I have object that need a rope to hook a load to move. I have to have the red circle in different position too.
In A,
If I change the position of the red circle, sometimes the rope stays there hanging the load. Is there anyway to update/reset, so it definitely follow the red circle? There are other time where it does follow, but the rope is swinging a lot. Is there any function to call that stop the swinging? It is just for a reset only.
In B,
If I have both of the them being fixed, the load just drops immediately, I don't know which way is the right way to set the joints up. Any suggestion?
Thanks.