13-12-2019, 10:46 AM
(13-12-2019, 10:31 AM)josemendez Wrote: Hi Christian,
This is because in sequential mode, constraints are grouped in batches to be able to simulate them in different threads.
Switch the bend/twist and/or stretch/shear constraints to parallel mode. This will somewhat hurt convergence, but you can make up for that by using more substeps or iterations. See:
http://obi.virtualmethodstudio.com/tutor...gence.html
Also, this post by DissidentDan is related (his point #3):
http://obi.virtualmethodstudio.com/forum...p?tid=1550
Hi Jose (hope I got the name right :-))
thanks for the quick answer! I will try and experiment with the parallel mode!
Cheers,
Christian