27-09-2017, 10:00 PM
(27-09-2017, 08:56 AM)josemendez Wrote: Hi there!
Since v3.2, just disabling the ObiRope component stops updating physics and the current rope mesh is preserved. This turns the rope into basically a static mesh, consuming 0 resources. If you later need to resume the simulation, you just have to re-enable the component.
Note that this approach keeps all the particles in memory, so while a deactivated rope does not consume processing power, it does consume additional memory compared to a simple mesh.
cheers!
Hi Jose - I have purchased and so far it does everything I need. Thanks for your reply. Man there are a lot of options! :-)