Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help  how to use obi handle
#10
(13-02-2019, 11:37 AM)Richard Wrote: When I select particles, the setting "pinned to, Offset, ..." immediately appears and "Add Pin Constraint"  dissappears. What you said is not happened.

Then that means the selected particle already has a pin constraint. Simply drag a ObiCollider to the "pinned to" slot.
Reply


Messages In This Thread
how to use obi handle - by Richard - 12-02-2019, 03:46 PM
RE: how to use obi handle - by josemendez - 12-02-2019, 04:05 PM
RE: how to use obi handle - by Richard - 13-02-2019, 04:15 AM
RE: how to use obi handle - by josemendez - 13-02-2019, 08:07 AM
RE: how to use obi handle - by Richard - 13-02-2019, 09:17 AM
RE: how to use obi handle - by josemendez - 13-02-2019, 09:51 AM
RE: how to use obi handle - by Richard - 13-02-2019, 10:06 AM
RE: how to use obi handle - by josemendez - 13-02-2019, 10:56 AM
RE: how to use obi handle - by Richard - 13-02-2019, 11:37 AM
RE: how to use obi handle - by josemendez - 13-02-2019, 01:51 PM
RE: how to use obi handle - by Richard - 13-02-2019, 02:38 PM