Help How to Make Obi Cloth Stiff and Heavy

[josemendez]

Thank you for your kind and helpful response.

In the blueprint, to increase the mass, I set the property to 'Mass', adjusted the 'Mass' value, and clicked the Done button. However, when I go back into the blueprint by clicking the Edit button again, the mass value is reset to 0.
It seems like the change isn’t being applied.

Is there something I’m doing wrong with the settings?

Hi there,

The value shown by the property field (mass, in this case) reflects the value of that property for the currently selected particle(s). If you have no particles selected, or if the particles are other ones than you set the value for, it will not show the value you expect.

kind regards,