19-03-2024, 07:23 AM
(This post was last modified: 19-03-2024, 07:24 AM by josemendez.)
(19-03-2024, 06:28 AM)inbilla Wrote: - I really do not need to resolution to be so high once the rope is uncoiled (the resolution of the green particle rope is fantastic for my situation, and obviously will be more performant). Is it possible for me to reduce the resolution of the rope at runtime? (I really hope so?)
Unfortunately not, you can't change the resolution of a rope at runtime. The reason is that resolution is a property of the blueprint (essentially a spline), not the rope itself.
You could build a second blueprint by resampling the rope particles as control points, reduce the resolution on this blueprint and then create a lower resolution rope from it at runtime, but it's quite involved and I doubt the results would look any good.
kind regards,