13-10-2023, 05:30 PM
(This post was last modified: 13-10-2023, 05:52 PM by josemendez.)
(13-10-2023, 01:38 PM)uatihb Wrote: Trying to setup a rope with variable thickness done by setting up multiple control points.
Hi!
I'm unable to reproduce this, tested with Obi 6.5.4 / Unity 2021.3.22 / Windows 10.
Created a new rope blueprint, assigned it to a ObiRope component, entered path edit mode and created multiple new control points. Then adjusted their radius to produce a variable-thickness rope. It's a fairly transited workflow.
(13-10-2023, 01:38 PM)uatihb Wrote: Can't really save it.
Do you mean the blueprint? It should be automatically saved after making any changes, but if there’s an exception/error it probably is preventing the changes from being saved.
(13-10-2023, 01:38 PM)uatihb Wrote: Works in editor, until it doesn't.
Ok, could you detail the steps that lead to it ceasing to work? I’m afraid your report isn’t very clear to me, all I know so far is that this error happens when manipulating control points somehow, but never ran into something similar myself or had any similar reports in the past. Stress-testing the system by haphazardly adding/editing/removing control points did not take me anywhere, I’ll need some more specific directions.
kind regards,