03-10-2023, 11:51 AM
(This post was last modified: 03-10-2023, 11:51 AM by josemendez.)
(03-10-2023, 09:15 AM)oriharu000 Wrote: I have a question, is it possible to make some small parts of the mesh sink deeper into the mesh?
Do you mean spatially varying elasticity? No, it's not currently possible.
(03-10-2023, 09:15 AM)oriharu000 Wrote: Or will there be any such development in the future?
We've been evaluating the possibility of implementing this, but would increase the cost of the simulation so it's unclear whether it will make it into the engine or at which point it will.
kind regards,