10-03-2023, 02:40 PM
(This post was last modified: 10-03-2023, 02:51 PM by rohit_dhak.)
So I have a custom pulley (with housing) setup which I want to use with Obi rope.
The housing is used to prevent the rope from slipping.
I am unsure on how to add collider to the housing of the pulley. I tried to add 2 separate box colliders on each side, however these colliders interacts with the pulley (rigid body) to cause unwanted aggressive movements of the pulley system.
I am attaching a photo of the pulley system. Any idea on how to achieve that would be really helpful.
Thank You.
The housing is used to prevent the rope from slipping.
I am unsure on how to add collider to the housing of the pulley. I tried to add 2 separate box colliders on each side, however these colliders interacts with the pulley (rigid body) to cause unwanted aggressive movements of the pulley system.
I am attaching a photo of the pulley system. Any idea on how to achieve that would be really helpful.
Thank You.