10-01-2023, 04:06 PM
(10-01-2023, 04:01 PM)patriot4947 Wrote: How can I do that with hinge joint. Can you explain a little more
Sure, simply add a HingeJoint component to your rollers, enable their "motor" checkbox, set a target velocity (the velocity at which they should rotate) and a motor force (the torque applied to make them rotate).
This should be trivial to do. If you're unfamiliar with physics in general I'd advise to get used to built-in rigidbodies and joints before moving on to softbodies. Otherwise you'll be in for a really steep learning curve, since softbodies are considerably more complex than rigidbodies.
cheers,