30-10-2022, 08:35 PM
(This post was last modified: 30-10-2022, 08:35 PM by MarieGrasmeier.)
Hi José,
been trying out obi rope for the entire day now and facing a lot of difficulties (as seems to be normal when new to it if I understand from this forum here :-)).
One issue is: I set up a rope in a test project (actually modified the fire hose sample by removing the pump script which I do not need). Everything looked quite nice in the test project. The I turned it into a prefab and imported it to an existing project: The problem: in this project, the rope (hose) is not affected by gravity, it just stays up in the air where it is.
I am not super sure if this is even an obi rope specific question but since it is not a rigidbody I am somehow lost and do not have an idea where to look for a solution. So please apologize in case this might be super off-topic.
Many thanks and best wishes,
Marie
been trying out obi rope for the entire day now and facing a lot of difficulties (as seems to be normal when new to it if I understand from this forum here :-)).
One issue is: I set up a rope in a test project (actually modified the fire hose sample by removing the pump script which I do not need). Everything looked quite nice in the test project. The I turned it into a prefab and imported it to an existing project: The problem: in this project, the rope (hose) is not affected by gravity, it just stays up in the air where it is.
I am not super sure if this is even an obi rope specific question but since it is not a rigidbody I am somehow lost and do not have an idea where to look for a solution. So please apologize in case this might be super off-topic.
Many thanks and best wishes,
Marie