Obi Softbody Car Deformation

[tufis16]

Hi,

Car deformation does not usually use softbodies. The reason for this is that softbodies are “soft” (as the name implies) and cars are made out of solid metal and hence fairly rigid. A good approach is using a rigidbody plus a MeshCollider that gets updated on collision. You can optionally use elastoplastic struts (like BeamNG) to determine the amount of permanent deformation on the mesh.

You can get softbodies to be more rigid, but at the expense of performance (by increasing the amount of substeps in your ObiFixedUpdater).

To get softbodies to “keep” their deformation, use the plasticity settings in the ObiSoftbody component. See: http://obi.virtualmethodstudio.com/manua...aints.html

Thank you so much you are helping too much <3