05-09-2022, 09:00 AM
(This post was last modified: 05-09-2022, 09:01 AM by josemendez.)
(05-09-2022, 08:54 AM)danazoid Wrote: The default settings
- barycentric weight: 1
- normal alignment weight: 1
- elevation weight: 1
Try using barycentric weight alone, set normal and elevation to zero. If you mesh contains corners or other sharp features it will help assign the correct weights to each particle.
May I ask why you're using particles so small? I couldn't help but notice that while particles were very small, the solver is then scaled up to compensate for the tiny particles, so not sure what the purpose of this is. I can't be 100% sure that such small sizes/masses won't cause floating point precision issues in some other parts of the simulation.
kind regards,