Hi, I can get collision to happen with one mesh, but with my desired mesh it is not colliding at all.
The 2 videos below are in the same scene. The Obi Solver setup is the same.
The colliders used to touch the cloth are setup in the same way, just different in size.
The mesh that works is "simpler" (vertices quite evenly spaced) and also 10x bigger than the one that doesn't.
What could be the issue? Thanks
Working https://www.youtube.com/watch?v=1tHRgr8oNyw
Not working https://www.youtube.com/watch?v=a5_nAQ1EU2Q
Also, if I may provide some feedback: my mesh particles were flying about and found that it was due to scaling (ie the transform scale was not 1, 1, 1). I spent some time troubleshooting this, it would have been good if the warning was in the manual somewhere...
The 2 videos below are in the same scene. The Obi Solver setup is the same.
The colliders used to touch the cloth are setup in the same way, just different in size.
The mesh that works is "simpler" (vertices quite evenly spaced) and also 10x bigger than the one that doesn't.
What could be the issue? Thanks
Working https://www.youtube.com/watch?v=1tHRgr8oNyw
Not working https://www.youtube.com/watch?v=a5_nAQ1EU2Q
Also, if I may provide some feedback: my mesh particles were flying about and found that it was due to scaling (ie the transform scale was not 1, 1, 1). I spent some time troubleshooting this, it would have been good if the warning was in the manual somewhere...