12-05-2022, 01:23 PM
(This post was last modified: 12-05-2022, 01:24 PM by josemendez.)
(12-05-2022, 01:07 PM)locque Wrote: Just tried the late fixed updater, unfortunately it didn't make any difference. I also tried different substep settings and the non-fixed late updater just in case.
Any other ideas? How do I find out what is causing it?
Could also be an issue with mass ratios, but that's less likely unless they're rather large. What's the mass of the container rigidbody vs the mass of each fluid particle (the mass of each particle appears in the fluid blueprint inspector, inside an info panel)?