09-03-2022, 10:52 AM
(This post was last modified: 09-03-2022, 10:53 AM by josemendez.)
(09-03-2022, 10:32 AM)guedbo Wrote: Hi Jose,
The blueprint stays thinking to generate it. It has been 30 minutes without advancing the load, I don't know if it's normal considering that other models don't reach 10 seconds.
If I want to continue I have to close from the task manager.
Is the mesh 2-manifold? non-manifold meshes are not supported as stated in the manual:
http://obi.virtualmethodstudio.com/manua...setup.html
Even though the generator will *try* to identify non-manifold meshes, malformations in the mesh can cause all sorts of issues. If you're unsure about manifoldness, I can help you identify issues with your mesh if you send it to support(at)virtualmethodstudio.com
kind regards,