Obi Softbody - Stop Movement

[alms94]

Hi there,

Both things are a consequence of Obi being a particle-based engine. If you add a ObiParticleRenderer component to your softbodies, the reason for this will become immediately obvious: particles are used to perform collision detection, not the mesh's surface.

There's many ways to work around this, some are:
- Just make your particles smaller (give them a smaller radius in the blueprint editor)
- Use a smaller mesh to generate the blueprint (or just scale the blueprint down, using its "scale" property)
- Use a small negative thickness for your ObiColliders, to compensate for particle radius.

let me know if you need further help.

kind regards,

That's what I exactly looking for. Thanks for your help and thanks for your quick reply