Paper (bank note) simulation

[josemendez]

Sure I did. I played with many parameters, and didn't get any even more or less suitable result.

Nothing to record there - the banknote just falls to the bottom plank, and the result is shown in the screenshot. 

You can see on the screenshot all values are set to 0. And yes, I played with a plasticity parameters as well, as I mentioned above.

As a base I took ClothStaticMeshCollider scene. Yes, bend constraints enabled and relaxation is 1


Duplicating part of my last message as I assume it was missed.

Ok! Will try to reproduce a good paper-like behavior and share the results with you.