26-11-2021, 10:04 PM
I created a cube (with default blueprint settings) and tried pressing down on the top of it with an Obi collider, but was not able to effect much change in it's surface. I tried adding in volume sampling, and playing with the shape matching constraints, but nothing seemed to make a difference.
Before I invest too much time trying to figure it out on my own, I just wanted to check to see if this is even possible? The effect I am going for is sort of like this.
I watched the tutorial videos and looked at the manual but was not able to find this addressed anywhere.
Before I invest too much time trying to figure it out on my own, I just wanted to check to see if this is even possible? The effect I am going for is sort of like this.
I watched the tutorial videos and looked at the manual but was not able to find this addressed anywhere.