Obi Official Forum › Obi Users Category › Obi Rope v
Rope twist at attachment point

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Rope twist at attachment point
josemendez Offline
Forum Admin
*******
Posts: 6,321
Threads: 24
Joined: Jun 2017
Reputation: 400
Obi Owner:
  • Rope
  • Cloth
  • Fluid
#2
15-11-2021, 08:49 AM (This post was last modified: 15-11-2021, 09:35 AM by josemendez.)
(15-11-2021, 01:49 AM)burspa Wrote: Hi

Is it possible to stop a rope from twisting at its attachment point? Using Rope extruded Renderer.

I would like the end control points to be clamped in place with no rotation. 

Perhaps I'm doing something wrong?

Cheers!

Ropes do not model twist/torsion, as explained in the manual:
http://obi.virtualmethodstudio.com/manua...setup.html

If you mean bending, using ropes you can just attach two control points that are very close to each other. This works because a single point in space does not determine a direction, however two points do.
Website Find
Reply


Messages In This Thread
Rope twist at attachment point - by burspa - 15-11-2021, 01:49 AM
RE: Rope twist at attachment point - by josemendez - 15-11-2021, 08:49 AM