Help ObiRope Points

[josemendez]

Thank you, I will redo it for physics. What parameter should I adjust so that my rope does not bend so much? I want her to be much more equal and not bend

Quoting my previous post:

"You can control bending using the rope's bend constraints:
http://obi.virtualmethodstudio.com/manua...aints.html

Increasing compliance will make ropes easier to bend.

Max bending determines the amount of bending at which ropes start to oppose bending. A value of zero means the ropes will always offer resistance to bending (how much resistance is determined by compliance). Higher values will allow the rope to easily bend for a bit, then start resisting bending."

Spending more iterations in bend constraints will allow the engine to reach higher bending stiffness. So:

- Set the rope's bend compliance to zero.
- Set the rope's max bending to zero.
- Increase the amount of bend constrain iterations in the solver.