Hi!
Goal: I want to tie the rope around some pillars and torque it as much as possible. However the rope starts twitching.
Here is a video. You can see the rope twitching eventhough plenty of rope is left. If project files are requested I am happy to share.
[video=youtube]http://https://youtu.be/w9YX9gTCd9c[/video]
Best,
Robert
(29-06-2022, 05:34 PM)roberthey Wrote: [ -> ]Hi!
Goal: I want to tie the rope around some pillars and torque it as much as possible. However the rope starts twitching.
Here is a video. You can see the rope twitching eventhough plenty of rope is left. If project files are requested I am happy to share.
[video=youtube]http://https://youtu.be/w9YX9gTCd9c[/video]
Best,
Robert
Hi Robert,
I assume you're using surface collisions, right? Increase the "surface collision tolerance" in the ObiSolver, a value like 0.1 - 0.15 should yield good results. You can also try using a few more substeps to increase collision quality.
kind regards,
(30-06-2022, 09:36 AM)josemendez Wrote: [ -> ]Hi Robert,
I assume you're using surface collisions, right? Increase the "surface collision tolerance" in the ObiSolver, a value like 0.1 - 0.15 should yield good results. You can also try using a few more substeps to increase collision quality.
kind regards,
Hi Jose,
will try and post how it goes. Thank you for your swift reply!
Best, Robert
(30-06-2022, 10:02 AM)roberthey Wrote: [ -> ]Hi Jose,
will try and post how it goes. Thank you for your swift reply!
Best, Robert
Just tried it and it works perfectly. Thank you so much!